The survey tells engineers which equipment can be reused, how many lanes are needed, where the controllers go and which gate to pilot. A survey at a quiet time only shows the layout; a survey at peak time shows the problem.
Six things to have ready
- A plan of the gates, the bike park and the doors to control, with a photo of each spot
- People through the gate and vehicles into the bike park per shift; shift start or school start times
- The equipment in use: card readers, controllers, gates, barriers, cameras, recorders, with brand and model
- The type of card issued to staff or students
- The current procedure for a lost card, a visitor, a vehicle whose exit does not match
- Who will use the software: guards, reception, HR, IT; the time and attendance or HR software in use
If you can, count the busiest 5 minutes in advance
Lanes are sized on the busiest 5 minutes, not the total for the shift. Before the survey, ask the guards to count vehicles through the bike-park gate in each 5 minutes of the peak, for a day or two. MSTAR engineers count again and time each pass in the lane.
During the survey
- Stand at the gate and the bike park through the peak, timing each pass
- Check the equipment in place against the device catalogue by brand and model
- Locate the controllers, network and power for each lane
- Agree the gate or lane to pilot, and the figures to measure
A measured pilot, with the criteria written down first
Rather than trust the figure in a brochure, try it on one gate or one vehicle lane of your own. Before installing, both sides write down the criteria: seconds per pass at peak time, vehicles or people per minute per lane, mismatched exits flagged. After the pilot, measure against exactly those criteria, then decide.